Alcatel-Lucent IAP93 Guia do Utilizador descarregar pdf (Página 151)

151 | Authentication AOS-W Instant 6.3.1.1-4.0 | User Guide

Figure 49 Admin Tab: Management Authentication Parameters

3. Under Local, select any of the following options from the Authentication drop-down list:

l Internal— Select this option to specify a single set of user credentials. Enter the Username and Password for

accessing the Virtual Controller Management User Interface.

l RADIUS Server— Specify one or two RADIUS servers to authenticate clients. If two servers are configured,

users can use them in primary or backup mode or load balancing mode. To enable load balancing, select

Enabled from the Load balancing drop-down list.

l RADIUS server w/ fallback to internal— Select this option to use both internal and external servers. When

enabled, the authentication switches to Internal if there is no response from the RADIUS server (RADIUS

server timeout). To complete this configuration, perform the following steps:

a. To enable load balancing, select Enabled from the Load balancing drop-down list.

b. Specify a Username and Password.

c. Retype the password to confirm.

4. Click OK.

In the CLI

To configure management authentication settings:

(Instant Access Point)(config)# mgmt-auth-server <server1>

(Instant Access Point)(config)# mgmt-auth-server <server2>

(Instant Access Point)(config)# mgmt-auth-server-load-balancing

(Instant Access Point)(config)# mgmt-auth-server-local-backup

(Instant Access Point)(config)# end

(Instant Access Point)# commit apply

Configuring 802.1X Authentication for a Network Profile

The AOS-W Instant network supports internal RADIUS server and external RADIUS server for 802.1X

authentication.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 334 335

Sem comentários

Alcatel-Lucent IAP93 Guia do Utilizador Página 151